Author Topic: C1300 4X4 International Trucks  (Read 925 times)

Offline Lionelgee

  • REMLR Inc
  • Full Member
  • *
  • Posts: 167
  • THANKS 18
  • Location: Bundaberg
  • REMLR No: 353PY
C1300 4X4 International Trucks
« on: January 17, 2020, 06:46:06 PM »
Hello All,

This is probably goes down as a dumb question... Did the 4x4 International C1300 trucks have a transfer box? Or was it one integrated unit?

I just came across a vehicle on the interwebby and it mentions that the engine is not included but the gearbox is. No close up photographs of the gearbox and I there are interior photographs of the cabin.

The last time I was in one of the 4x4 it was a van way back in the 1970s when I was in primary school.

I am just concerned that when one of these come available . . . . and I have enough spare cash . . . . that I miss out buying the essential part that makes these vehicles capable of four wheel drive.

Are the parts for the transfer case still available? Are they a Dana unit?

Kind regards
Lionel

Offline GGG

  • Full Member
  • ***
  • Posts: 212
  • THANKS 29
  • Location: Sydney
  • REMLR No: 428
Re: C1300 4X4 International Trucks
« Reply #1 on: January 18, 2020, 08:12:01 PM »
From memory the C1300s were 4x2 so were CLs rather than GS therefore no transfer case. I think that domestic transport platoons like 390 at Ingleburn had them. The 4x4s were AB series as far as I can recall.
Geoff O.

Offline john.k

  • Full Member
  • ***
  • Posts: 190
  • THANKS 29
  • Location: brisbane
Re: C1300 4X4 International Trucks
« Reply #2 on: February 19, 2020, 03:00:13 PM »
The C1300,and all the rest of the 4x4s have a transfer case separate to the gearbox..Common one is the New Process 205...the 1400s had a heavier(slightly) duty unit ,New Process 206.

Offline GGG

  • Full Member
  • ***
  • Posts: 212
  • THANKS 29
  • Location: Sydney
  • REMLR No: 428
Re: C1300 4X4 International Trucks
« Reply #3 on: February 22, 2020, 07:23:15 PM »
My knowledge of normal control Inters is pretty basic. However I would like to know why a relatively small truck which does not have four wheel drive would require a transfer case. I am not trying to be clever I am just interested.
Geoff O.

Offline john.k

  • Full Member
  • ***
  • Posts: 190
  • THANKS 29
  • Location: brisbane
Re: C1300 4X4 International Trucks
« Reply #4 on: February 23, 2020, 02:42:41 PM »
Thats quite right ,but the OP is asking about /and thread title is C1300 4x4 Inters.

Offline GGG

  • Full Member
  • ***
  • Posts: 212
  • THANKS 29
  • Location: Sydney
  • REMLR No: 428
Re: C1300 4X4 International Trucks
« Reply #5 on: February 23, 2020, 08:09:21 PM »
No worries it is just that in my time of snooping around such places as 2 BOD and 2 Base workshops I never came across a 4 X 4 C1300. That was 1970/71.
Geoff O.