Author Topic: Fuses  (Read 801 times)

Offline Perentie1989

  • Newbie
  • *
  • Posts: 18
  • THANKS 0
  • Location: Central Coast
Fuses
« on: October 25, 2019, 09:28:17 PM »
Hi all,

All the fuses in my perentie are set to blow at a much higher amp than listed on the schedule - is that common to these vehicles.

Also in seeking replacement glass fuses I haven't been able to obtain any of the same length - over the counter fuses are either too short or a little long which still can fit but not snuggly.  Any advice on a source of fuses?

Thanks, David

Offline Carzee

  • REMLR Committee
  • Veteran
  • ***
  • Posts: 3371
  • THANKS 156
  • Perentie FFR 50-257
    • Perentie Wiki
  • Location: Canberra
  • REMLR No: 007
Re: Fuses
« Reply #1 on: October 26, 2019, 12:21:52 PM »
Hi David, i looked at the parts book and thete are some 30mm length, some 22mm length.

I have not owned one with the early set up (glass fuses).

Offline Perentie1989

  • Newbie
  • *
  • Posts: 18
  • THANKS 0
  • Location: Central Coast
Re: Fuses
« Reply #2 on: October 26, 2019, 12:59:56 PM »
Thanks, I'll search for a supplier who can supply at those lengths and let the forum know.

Offline Ford Blitz

  • Sr. Member
  • ****
  • Posts: 264
  • THANKS 11
  • Location: Springfield
Re: Fuses
« Reply #3 on: October 26, 2019, 03:21:13 PM »
measure the length and amps and let me know I suspect I have spares that can help you out.
Tom

Offline Perentie1989

  • Newbie
  • *
  • Posts: 18
  • THANKS 0
  • Location: Central Coast
Re: Fuses
« Reply #4 on: October 26, 2019, 09:24:51 PM »
Hi tom,
Most are 8amp (32V DC) x7, 10amp (12V DC) x4, a 12amp, a 2.5amp and a 5amp (32V DC).  All 30mm long 6.3mm dia.

Let me know if you have any.

Thanks, David

Offline Ford Blitz

  • Sr. Member
  • ****
  • Posts: 264
  • THANKS 11
  • Location: Springfield
Re: Fuses
« Reply #5 on: October 28, 2019, 10:46:40 AM »
PM your address and I will send you what I have spare.
Tom

Offline Perentie1989

  • Newbie
  • *
  • Posts: 18
  • THANKS 0
  • Location: Central Coast
Re: Fuses
« Reply #6 on: November 02, 2019, 04:12:53 PM »
Sent, thanks muchly Tom