Author Topic: Instruction Decal  (Read 1714 times)

Offline Andrew L

  • Newbie
  • *
  • Posts: 28
  • THANKS 3
  • Location: Australia
Instruction Decal
« on: February 10, 2018, 02:49:53 PM »
 Hi All,
 Recently Purchased a 6x6 Army Acco fire truck and a Mark 3 Military Acco as a Job Lot.
 The Instruction Plate on the 6x6 has worn off would someone please have a picture of this or Know where I may be able to buy one?
 Im not certain of the directions to go from Road use to 6x6,I did drive these years ago in the NSW Bush Fire Brigades but forget.
 I also need 1 x Tac Plate Holder.
 Also a full set of the Windscreen Arms that allow you to Fold out the front windscreens.

 Planing to Restore the Military 4x4 as that and the 6x6 as a Fire truck,will have lots more questions as I get into it.

Thanks in advance,
BTW Also have a 1991 Land Rover Perentie Radio Vehicle I have had for several years
Andrew Lane

Offline Chazza

  • REMLR Inc
  • Hero Member
  • *
  • Posts: 570
  • THANKS 99
  • Location: Narrogin
  • REMLR No: 217
Re: Instruction Decal
« Reply #1 on: February 10, 2018, 04:03:35 PM »
Nice find Andrew!

I make truck tac-plate holders; PM me if you would like one,

Cheers Charlie
S2 Command Recce '59
S2A 109" GS '63
S2A Fire Truck '64

Offline Ravvin

  • REMLR Inc
  • Hero Member
  • *
  • Posts: 586
  • THANKS 61
  • Location: Wesley Vale, Tasmania
  • REMLR No: 432
Re: Instruction Decal
« Reply #2 on: February 10, 2018, 04:33:30 PM »
Looks like you're in luck.
Have a read here ->

Welcome to the forum.