LT95 torque settings

[cinan]

I am changing the rear output seal on my LT95 gearbox.  Does anyone have the torque setting for the main locking nit handy ?  I have seen it somewhere but can't find it now.

Thanks
Andrew

[Philthy]

I am changing the rear output seal on my LT95 gearbox.  Does anyone have the torque setting for the main locking nit handy ?  I have seen it somewhere but can't find it now.

Thanks
Andrew

Your answer is in here http://www.landroverweb.com/Pdf-files/Manuals/Defender-90-110-workshop-manual-3.pdf

Have a big breakfast and get a long pipe 

[cinan]

Thanks but this doesn't provide the Torque settings,  it just says to tighten the locking nut to the correct torque without specifying the amount ?

[cinan]

I found the data I need for anyone else needing this information here it is for the LT95 Torque.  All specs are in Nm.

GEARBOX AND TRANSFER BOX LT95 .V8 P etrol engine
Bell housing to cylinder block bolts .......................... 36, 6 . 44, 8
Gearbox casing to bell housing 2 off ......................... 146,3 . 179
Gearbox casing to bell housing 2 off .........................85, 4 . 104, 4
Gearbox casing to bcll housing stud and nuts ..............85, 4 . 104, 4
Gearbox casing to bell housing nuts .......................... 146, 5 . 179
Output flange -rear - nut and bolts ....................... 43, 4 . 513
Output shaft -rear - nut ..................................... 146, 5 . 179
Output shaft - front - nut .................................... 146, 5 . 179
Gear selector spherical scat bolts ............................. 13, 6 . 16, 3
Propeller shaft to flange bolts .................................43, 4 . 51, 5
All other nuts and bolts:
M6 ................................................................ 9, 9 . 11, 9
M8 ................................................................ 23:7 . 29.7
M10 ............................................................... 48 . 58