« previous next »
Pages: 1 [2]

Author Topic: Workshop Lathe  (Read 16073 times)

Offline Tommy

  • Sr. Member
  • ****
  • Posts: 317
  • THANKS 72
  • Location: Perth, Western Australia
  • REMLR No: 209
Re: Workshop Lathe
« Reply #15 on: March 15, 2015, 05:53:11 PM »
Nice photo of the Hercus lathe as used on the workshop. This lathe has been relocated off the workshop platform to a 'stand alone' position. I notice the operator has been busy cutting the cartridge casing off 105mm shells leaving just the casing base and primer tube. There are a few on the floor at his feet. Anyone know what that is about?

Also notice the small 'draws'? (on their sides) the lathe is sitting on. They appear to be a Land Rover going by the latch on each. I notice that they are the same 'draws' as shown on the other photo. It doesn't look right that they are sitting on their side. Were they originally 'draws' or are they simply mountings for the lathe to sit on? The latch confuses me.
« Last Edit: March 15, 2015, 06:09:25 PM by Tommy »
Logged

Offline AGAS 5

  • Hero Member
  • *****
  • Posts: 992
  • THANKS 261
  • REMLR 218
  • Location: Great Southern Land
  • REMLR No: 218
Re: Workshop Lathe
« Reply #16 on: March 15, 2015, 06:03:33 PM »
Hi Stuart,

My 2c ...

Ash trays or .... to prevent re-use as, what we now call, Improvised Explosive Devices (IED's)

Thanks for the pic.

Pete
 
Logged
Series 2A SWB 113-300 VTF  6 RAR
Perentie FFR 49-290  2 Sig Regt
Perentie FFR 49-390  1 MP BN
Perentie GS 50-087  5 RAR

Offline glbest

  • Sr. Member
  • ****
  • Posts: 461
  • THANKS 20
  • Location: bne
Re: Workshop Lathe
« Reply #17 on: November 23, 2022, 01:07:38 PM »
looking for plans for a portable workshop bench
Logged
Pages: 1 [2]
« previous next »