Perentie FFR distribution board, generator and cables

[Phil B]

Hi,

I have the following for sale from a 1988 Perentie FFR:
distribution board in good condition, complete $150
Cables set needs new cables as the insulation is brittle $25
Generator in good condition, not checked $100
2x aerial mounts $50 ea
2 x fold door rear seats, solid but need refurb, no cushions $30 ea
all excluding postage/freight
Sorry about the quality of the photo's, it was dark !!
Phil B
0402080227

[Phil B]

Still for sale...
Distribution box $150
Generator incl cables and brackets $100
Rear seats $30ea
Phil

[Mick_Marsh]

Did you get my PM?

[Phil B]

Mick,

Sorry, missed that one.
Yes it comes with the two circular brackets.
Phil.

[Mick_Marsh]

My PM

Do you also have the brackets that bolt this generator to the engine?

So (and others may help here), all I need to attach this generator to my 4BD1T is included?
If that is the case, yep, I'll buy it.
regards
Mick

[dugite]

OK, Mick - you should also be supplied with the tensioner and it's fittings for the drive belts that run off the crankshaft pulley

[dugite]

Unless, of course, the seller may be keeping the fittings for an a/c installation

[Mick_Marsh]

OK, Mick - you should also be supplied with the tensioner and it's fittings for the drive belts that run off the crankshaft pulley

Got that.
So, how do the rings attach? Both to the generator and the vehicle?

[FFRMAN]

OK, Mick - you should also be supplied with the tensioner and it's fittings for the drive belts that run off the crankshaft pulley

Got that.
So, how do the rings attach? Both to the generator and the vehicle?

Mick,

they simply slip onto the generator, but there is also a bracket that they attach too that fixes it to the block - I'll get a photo pf mine tomorrow,

[303Gunner]

Isn't the bracket the LHS Engine Mount?

The rings that wrap around the Genny have flat tabs on the side closest to the engine. These are fitted to the sides of the LH engine mounting bracket.

The tensioner bolts to the front of the engine block and is spring loaded to open out and apply tension to the belts.

[Mick_Marsh]

Isn't the bracket the LHS Engine Mount?

The rings that wrap around the Genny have flat tabs on the side closest to the engine. These are fitted to the sides of the LH engine mounting bracket.

The tensioner bolts to the front of the engine block and is spring loaded to open out and apply tension to the belts.

Yep.
I don't have this bracket:

So, I'll be needing it too.