Recent Posts

41

REMLR - General Chatter / anzac day support for Coorparoo RSL march

« Last post by glbest on November 29, 2024, 01:14:47 PM »

Good Afternoon.
my name is gregory best and I am organising the annual RSL March at Coorparoo qld . I requesting for support as we have several members that that are no longer able to march and request if there are members who can donate approximately 2 hours of their time and vehicles to assist the RSL the parade commences at 730 muster time and march of is 0800 hours the parade will take about 20 mins anticipate completion time is 0830.


please advise


gregory best

42

REMLR - General Chatter / Re: REMLR

« Last post by Mick_Marsh on November 27, 2024, 01:29:46 AM »

Things have slowed on other fora and facebook.
Maybe we have said all there is to say.

Me, my computer has gotten old and is difficult to use on facebook. I also seem to not have as much free time.
I should post up some pics of this year's Dookie display.

43

REMLR - General Chatter / Re: Full 24V Series 2 FFW???

« Last post by fc101 on November 26, 2024, 03:45:52 PM »

Aussie 101s are fully 24v but then they are not Series 2s.

44

REMLR - General Chatter / Full 24V Series 2 FFW???

« Last post by Phoenix on November 26, 2024, 11:31:08 AM »

Looking through some documents that came into my hands there is a wiring diagram for what I thought was a Fitted For Wireless, however the whole vehicle is 24v, headligthts, engine, all.  I've never seen any full 24v Australian vehicles, has anybody else?? 

Perhaps this was a proposed vehicle never accepted?

45

New Member Introductions / Re: New Owner and Member

« Last post by STDDIVER on November 22, 2024, 06:57:26 PM »

Welcome to REMLR Randall - Great to see another landy saved.  Cheers     STDDIVER

46

REMLR - General Chatter / Re: REMLR

« Last post by GGG on November 21, 2024, 07:16:20 PM »

Phoenix, I hope that you are correct as the site is a mine of information not to mention a certain amount of entertainment.
Cheers, Geoff O.

47

REMLR - General Chatter / Re: REMLR

« Last post by Phoenix on November 21, 2024, 03:26:26 PM »

Facebook always took a chunk of the traffic here, but the problem is re finding information again, which the forums here excel at.  I suspect in time facebook will loose popularity and people come back in here.

48

REMLR - General Chatter / Re: Lifting off a Topographical Module

« Last post by Phoenix on November 21, 2024, 03:24:50 PM »

I'm not sure topographical body is the right description, it's an ambulance body converted to electronic repair vehicle.   https://www.remlr.com/Ambulance-erv.php

Whilst it's similar to the series 3 topographical Survey vehicle featured on this page, I believe that was a one off prototype that the army never adopted (Chassis No. Unknown).   https://remlr.com/lrprpics.html

49

New Member Introductions / Re: New Owner and Member

« Last post by Chazza on November 19, 2024, 09:14:38 AM »

Welcome Randall.

Nice looking Rover you have there,

Cheers Charlie

50

Bodywork & Painting / Re: Protec Paint

« Last post by gromit on November 18, 2024, 08:29:11 PM »

I don't understand why rattle can paint would fade less than paint in a 4 litre can but...... it could depend on the thinners used and the percentage.

It often pays to test these things before opining that a fellow Perentie/mil LR enthusiast is outright wrong

I'm surprised that you think i suggested that someone was outright wrong as I didn't.

The colour of the sleeve on the can and the fact that Protec list a light tan was my initial concern.
I'd also read that the military paint supplier had changed in the past and, for example, that the Protec green wasn't 'correct' but that was probably Series II rather than Series III.
The light tan may be a better match but the Brown isn't far off allowing for fading on my Series III FFR.

The data sheets for both the 4 litre & spray cans list IRR properties.

Colin