« previous next »
Pages: [1]

Author Topic: 12 Pin "NATO" Trailer plug on No.5 trailer  (Read 1009 times)

Offline dugite

  • REMLR Committee
  • Veteran
  • ***
  • Posts: 1083
  • THANKS 103
  • Location: Tamworth
  • REMLR No: 374
12 Pin "NATO" Trailer plug on No.5 trailer
« on: May 12, 2020, 01:35:42 PM »
Hi all,

I'm just renewing the old weathered wiring in a No.5 trailer.

I would appreciate if anyone can let me know how to access the rear of the trailer plug to reach the rear of the pin terminals.

Does the metal section push forward out of the rubber containment? If so does anyone have any tips how to go about this.

thanks - Laurie
Logged
2a 109 114-341,
No.5 173-589,
W/S Platform 178-000,
PT1 204-796

Offline Sixty

  • Sr. Member
  • ****
  • Posts: 325
  • THANKS 77
  • Location: CQld
Re: 12 Pin "NATO" Trailer plug on No.5 trailer
« Reply #1 on: May 12, 2020, 06:24:32 PM »
Laurie,
Loosen the hose clamp (if fitted), push the cable into the plug, and then using a small flat screwdriver, lever the grey rubber bung out the front of the nato plug.
Logged
RoyalAustralianEasyMoneyEarner!

Al

Offline dugite

  • REMLR Committee
  • Veteran
  • ***
  • Posts: 1083
  • THANKS 103
  • Location: Tamworth
  • REMLR No: 374
Re: 12 Pin "NATO" Trailer plug on No.5 trailer
« Reply #2 on: May 12, 2020, 07:14:35 PM »
well described Sixty, thank you very much 😀
Logged
2a 109 114-341,
No.5 173-589,
W/S Platform 178-000,
PT1 204-796
Pages: [1]
« previous next »