Vehicle Variants > Trailers
Crump & Cornish trailer hubs
(1/1)
Mick_Marsh:
I'm about to repack the bearings on the BAE Systems trailer (after I replace the brake backing plate).
Would anyone know what torque I should tighten the hub nut up to?
BEARMAN:
Just like a normal wheel bearing Mick. Up tight then back off a small bit until it spins freely.
Mick_Marsh:
--- Quote from: BEARMAN on November 09, 2023, 07:53:48 AM ---Just like a normal wheel bearing Mick. Up tight then back off a small bit until it spins freely.
--- End quote ---
Thankyou.
Navigation
[0] Message Index
Go to full version