My Mk3

[harby]

Finally got over to get some work done to my Mk3 which have previously posted about on the old AULRO forums.

We were hoping to actually bring it home, however after 1800kms of driving all over the country side (including a 600km round trip to Pt Lincoln for some parts) we have had to leave the old girl where she was, as she needs a couple of new brake lines. Hopefully we will make it over there in april after the birth of our baby to finish off a couple of jobs and bring her home!

After sitting so close to the sea, the old girl is looking a bit worse for wear and quite a bit of metal cancer has set in, but we have it purring like a kitten, and hopefully once we have sorted out the brake lines, we can bring it home! Then its probably going to be time to make a decision whether it gets a new cab (any suggestions??) or whether we will be able to salvage what small amount is left of the current one.

A few pics:













And all loaded up with gear at home to go and work on the old girl:

[dkg001]

It looks like you have a project there, what are your plans for it. In regard to the cab it is always easier to replace rusted panels, however good replacement cabs are very rare, the photos might not be showing up how bad the rust is, but on the face of it I have seen worse repaired. 

[Mick_Marsh]

Nice one. I like it.
I take it the crane was "in service"?
That crane would be so handy.

[skippy down under]

Yes I agree, that cab should be able to be repaired. Just takes time & money. Take your time. You still have that on your side.
I also got into the hobbie when our kids were just born. Its a great family hobbie, also for camp outs & with a canopy & seats, taking glasses out to the school camps. We have had our Mog for sixteen years & the wife says we will never sell.! Its so handy.
Stephen