Author Topic: Isri Seats  (Read 583 times)

Offline Marlin

  • Full Member
  • ***
  • Posts: 114
  • THANKS 10
  • Location: Sunshine Coast
Isri Seats
« on: April 11, 2018, 03:46:14 PM »
Hi all

Would someone be able to advise me on how to remove the head rests from Isri seats in a 4x4 perentie. They are attached with two metal rods that go through a plastic collar in the seat back. I've tried the usual pulling and squeezing the collar, but they do not want to release. Is there a special knack to getting them off? I've bought seat covers and I need to remove the head rests to fit them.

Many Thanks


  • Hero Member
  • *****
  • Posts: 608
  • THANKS 89
  • Location: Hay Point
  • REMLR No: 430
Re: Isri Seats
« Reply #1 on: April 11, 2018, 03:56:30 PM »
Usually they just click out over a detent thingy but a lot of them are frozen in position from moisture ingress. One on my 6x6 won't come out so I put velcro on the bottom of the headrest cover and fitted it over from the top.
09/1998 Perentie 6X6 ARN202516 - BRUTUS


  • REMLR Inc
  • Sr. Member
  • *
  • Posts: 396
  • THANKS 47
  • Location: Portland Vic
  • REMLR No: 482
Re: Isri Seats
« Reply #2 on: April 11, 2018, 04:22:06 PM »
Tap one side of the head rest and then the other, gently applying increasing opposing force from the base of the headrest away from the seat - (you can give a squirt of CRC or similar product before applying this technique, have a cuppa and when finished the cuppa - tap again - they all come out).   ;)   Inform your vehicle that "Resistance is futile!"